Shove the new valve into the hole and screw on the new locknut one-quarter turn past hand tight. To install the new flush valve, push the tapered washer onto the end of the threads and seat it so that the tapered end faces the threaded end. If you pull the refill tube from the overflow pipe, the flush valve will lift out. Next, remove the spongy-looking spud gasket by pulling it off, and then use either water pump pliers or a spud wrench to remove the locknut (this holds the flush valve in place). Gently lift the tank and set it on its side. Remove the tank from the bowl by unbolting it from underneath (you may have to hold a screwdriver on the bolt to keep it from turning as you remove the nut). So, you will need to turn off the water to the toilet, disconnect the supply line to the fill valve and drain the water from the tank. Replacing the flush valve is a chore, as it involves removing the tank from the bowl. So, the jelly will fill in the areas and prevent leakage at the points where water got between the flapper and the damaged seat. What makes this work is that on the bottom of the unit is a jelly-like substance that seals against the damaged seat of the flush valve. The flush fixer is a hinged flapper/seat assembly that sits on top of the flush valve, exactly where the old flapper went. You can either replace the flush valve or you can try a product called a “flush fixer.” If pushing down on the flapper doesn’t help, you probably need to replace the flush valve or you may have a cracked tank. Try feeling around the rim of the flush valve for divots, cracks or deposits. If the water stops trickling into the bowl, you have found your problem.Įven if you replace the flapper, it may not fit correctly, or there may be damage to the rim sealed by the flapper. Stick you arm into the tank (don’t worry, the water is clean) and push down on the flapper. It is located in the center of the tank and has the overflow pipe rising out of it. The flush valve (aka Douglas valve) is what the flapper sits on. ![]() The problem is usually with the flapper or flush valve assembly. If the water in the tank is running into this pipe (it’s the one in the center of the tank about the diameter of a quarter), then simply adjust the float level down so that the water shuts off earlier. Begin by making sure the float is set at a level that won’t allow water to run into the overflow pipe. ![]() There are many possible explanations for the leak, but let’s start with the easy ones. That’s a dead giveaway that water is leaking from the tank. It wastes water just as a bigger leak does and can interrupt your sleep when the toilet starts to fill for no apparent reason. What else should I do?Ī: That tiny trickle can be frustrating. I have replaced the flapper, but the problem persists. The water from the tank is slowly leaking into the bowl, and I can’t figure out why.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |